Студопедия — Instrument Transformers
Студопедия Главная Случайная страница Обратная связь

Разделы: Автомобили Астрономия Биология География Дом и сад Другие языки Другое Информатика История Культура Литература Логика Математика Медицина Металлургия Механика Образование Охрана труда Педагогика Политика Право Психология Религия Риторика Социология Спорт Строительство Технология Туризм Физика Философия Финансы Химия Черчение Экология Экономика Электроника

Instrument Transformers






Instruments transformers are made for use with control devices and measuring instruments to extend their range and for isolation of these devices and instruments from high-voltage current-carrying parts. They are of two kinds, namely, voltage (potential) trans­formers and current transformers.

Voltage transformers do not differ in design from ordinary low-power transformers. The primary (HV) winding of such a transformer is connected to two line wires of the circuit the voltage of which is to be measured or controlled, while the secondary (LV) winding is connected to a voltmeter, or to the parallel coil of a wattmeter, watthour meter, etc. The turn ratio of a voltage transformer is chosen such that the secondary voltage is equal to 100 V at the rated primary voltage.

The operation of this transformer is similar to the no-load oper­ation of an ordinary transformer because the resistance of a volt­meter or the resistance of the parallel coil of a wattmeter or a watt-hour meter is high and the current in the secondary can he neglected. It is undesirable to connect many meters to the secondary. If we connect one more voltmeter in parallel with the voltmeter placed across the secondary or connect the parallel coil of a wattmeter or a watthour meter, the current in the se­condary will grow and the subsequent voltage drop across the secondary termi­nals will decrease the accuracy of readings of the meters.

Current transformers serve to convert a high current in the primary to a low secondary current such that its value is equal to 5 A. The primary is placed in series with the metered circuit, namely, at the break of the line wire the current of which is to be measured, while the secondary is connected in series with an ammeter or with the series coil of a wattmeter or a watthour meter, i.e. with a meter of low impedance.

The operation of a current transformer differs substantially from that of an ordinary transformer. In the latter, a change in the load does not practically cause a change in the magnetic flux through the core if the impressed voltage remains stable. As the secondary cur­rent in the ordinary transformer decreases, so does the primary cur­rent. If the secondary carries no load (the circuit is open), the prim­ary current drops to an open-circuit current I 0.

In a current instrument transformer, the secondary carries a load (meter coil) of low impedance and the transformer operates in almost short-circuit conditions. Therefore, the magnetic flux in the trans­former magnetic circuit is small. If we disconnect the instrument from the secondary, the secondary current will disappear, whereas the primary current will remain invariable.

Thus, when the secondary of a current transformer is open, the core flux set up by the primary current does not encounter the oppos­ing action produced by the secondary current and increases greatly. The secondary voltage that rises correspondingly may break down the insulation of the secondary and offer a hazard to the operating personnel. For this reason, the secondary winding should be short-circuited before the load on the secondary is removed.

A large number of instruments connected to the secondary of a current transformer decreases the accuracy of measurement.

Current transformers greatly vary in design and can be stationary and portable depending on the purpose they have to serve.

High voltages on the primary side of voltage and current trans­formers may break down the primary winding insulation and cause the electrical connection between primary and core or between primary and secondary. To ensure safety for operators, the cores and secondaries of instrument transformers must be grounded. The symbols of instrument transformers appear in Fig. 6.8.

 







Дата добавления: 2015-09-04; просмотров: 472. Нарушение авторских прав; Мы поможем в написании вашей работы!



Важнейшие способы обработки и анализа рядов динамики Не во всех случаях эмпирические данные рядов динамики позволяют определить тенденцию изменения явления во времени...

ТЕОРЕТИЧЕСКАЯ МЕХАНИКА Статика является частью теоретической механики, изучающей условия, при ко­торых тело находится под действием заданной системы сил...

Теория усилителей. Схема Основная масса современных аналоговых и аналого-цифровых электронных устройств выполняется на специализированных микросхемах...

Логические цифровые микросхемы Более сложные элементы цифровой схемотехники (триггеры, мультиплексоры, декодеры и т.д.) не имеют...

Основные разделы работы участкового врача-педиатра Ведущей фигурой в организации внебольничной помощи детям является участковый врач-педиатр детской городской поликлиники...

Ученые, внесшие большой вклад в развитие науки биологии Краткая история развития биологии. Чарльз Дарвин (1809 -1882)- основной труд « О происхождении видов путем естественного отбора или Сохранение благоприятствующих пород в борьбе за жизнь»...

Этапы трансляции и их характеристика Трансляция (от лат. translatio — перевод) — процесс синтеза белка из аминокислот на матрице информационной (матричной) РНК (иРНК...

Весы настольные циферблатные Весы настольные циферблатные РН-10Ц13 (рис.3.1) выпускаются с наибольшими пределами взвешивания 2...

Хронометражно-табличная методика определения суточного расхода энергии студента Цель: познакомиться с хронометражно-табличным методом опреде­ления суточного расхода энергии...

ОЧАГОВЫЕ ТЕНИ В ЛЕГКОМ Очаговыми легочными инфильтратами проявляют себя различные по этиологии заболевания, в основе которых лежит бронхо-нодулярный процесс, который при рентгенологическом исследовании дает очагового характера тень, размерами не более 1 см в диаметре...

Studopedia.info - Студопедия - 2014-2024 год . (0.011 сек.) русская версия | украинская версия