Elastic impact

 

The experimental installation to study the perfectly elastic impact consist of two rods with suspended balls, the scale for measurement of angles, a generator of elastic pulses and a device to count the pulses. Electric pulses pase through the balls of there is a contact between those balls. It is possible to obtain the bodies interaction time (impact time) if we know the numbers N of electric pulses having passed the balls during impact time and the same numbers N having passed at a second. Evidently can be calculated by the formula

(11.1)

Mean balls interaction force (mean impact force) can be calculated by the formula, which shows change of momentum of the body and impulse of the force

,

where F is a mean impact force, Δτ; is the mean impact time; FΔτ is the impulse of the force; Δp is the change of body momentum.

Hence

,

where v₀ is the body velocity before the impact, v is the body velocity after the impact(v = 0 in our case). According to the law of conservation of mechanical energy

and

,

where h is a height of the lifted ball. If the rod length is equal to l then we can write (according to figure 11.1)

 

Figure 11.1

 

(11.2)

Here F is interaction force. You have to count the impact force in this laboratory work. To do this it is necessary to determine numbers N and numbers N₀ of electric pulses at the beginning. For that you have to

1) switch on the device ПС02-2M;

2) wait for 5 - 7 minutes to warm up the device;

3) press the key "M" and "f";

4) connect the balls together (with you hand) and press them to each other for good electric contact and press the key "cбpoc" and then "ПУСК";

5) look at the indicator and write down the numbers of pulses passing during 1 second - N₀;

6) repeat this measurement process four times (you must have five measurements of value N₀).

Then you have to obtain the value of N. To do that you have to

1) press the key "100";

2) deviate one of the balls at the angle φ= 10⁰;

3) release the ball and press the key "ПУСК" simultaneously;

4) press the key "СТОП" after the first balls impact;

5) write out the value N from the indicator;

6) repeat your measurement process four times (you must have five measurements of N).