Cargo and Vehicle Inspection Systems

The Cargo Scan systems are state-of-the-art portal high-energy scanners for inspection loaded vehicles (container or general cargo), designed especially requirements of high throughput and cost-effective screening cargo. Thanks to drive-through operation mode allowing the vehicle to be driven through portal configuration directly, the traffic flow will not be impeded by inspection process. The systems enable screening the vehicle/container automatically at up to 150-180 units per hour with steel penetration up to 270-300 mm.

The ADANI selected approach would be possible to integrate cargo screening systems into normal cargo operational flow. This would reduce the overall operational area, maintain a clean traffic flow and minimize total costs of screenings.

The Cargo Scan systems, which designed as X-Ray Drive-Thru Portal (DTP), are available in movable (easily relocatable) and mobile configurations.

Cargo Scan DTP-5000R
Movable Cargo Inspection System

 

Movable cargo inspection system with compact 5 MeV-accelerator is cost-effective solution for the detection of illegal consignments inside trucks and sealed containers in free-flow mode operation. It can up to 270 mm steel penetration and inspect 150-180 containers per hour depends on energy. All system components, including the X-ray portal, control and X-ray modules are designed for easy disassembly and relocation during few days.

• Cargo Scan DTP-5000M
  Mobile Cargo Inspection System

Mobile cargo inspection system is designed for the x-ray screening of fully loaded containers and trucks. Its 100% mobility is perfectly suited for spot checks in any location.

The scanner with 5 MeV-accelerator can penetrate up to 270 mm of steel and inspect 150-180 trucks per hour.
The system is ready for use anywhere in less than 120 minutes.

 

Task II. Rewrite the sentences below translating the Russian parts into English:

1. Мобильный рентгеновский комплекс is designed for the x-ray screening of fully loaded containers and trucks.

2. Поток автодорожного транспорта will not be impeded by inspection process.

3. The Cargo Scan systems are state-of-the-art portal high-energy scanners for досмотр большегрузных автомобилей.

4. The ADANI selected approach would be possible to преобразовать процесс рентгено-телевизионного досмотра into normal cargo operational flow.

5. The scanner with 5 MeV-accelerator обладает проникающей способностью через сталь толщиной до 270 мм and inspect 150-180 trucks в час.

Task III. Give the gist of the text “Cargo and Vehicle Inspection Systems”.

 

Text 3