Gasoline

Motor gasoline, or petrol, must meet three primary requirements. It must provide an even combustion pattern, start easily in cold weather, and meet prevailing environmental requirements.

Octane rating. In order to meet the first requirement, gasoline must burn smoothly in the engine without premature detonation, or knocking. Severe knocking can dissipate power output and even cause damage to the engine. When gasoline engines became more powerful in the 1920s, it was discovered that some fuels knocked more readily than others. Experimental studies led to the determination that, of the standard fuels available at the time, the most extreme knock was produced by a fuel composed of pure normal heptane, while the least knock was produced by pure isooctane. This discovery led to the development of the octane scale for defining gasoline quality. Thus, when a motor gasoline gives the same performance in a standard knock engine as a mixture of 90% is octane and 10% normal heptane, it is given an octane rating of 90.

There are two methods for carrying out the knock engine test. Research octane is measured under mild conditions of temperature and engine speed (49°C and 600 revolutions per minute, or RPM), while motor octane is measured under more severe conditions (149°C and 900 RPM). For many years the research octane number was found to be the more accurate measure of engine performance and was usually quoted alone. Since the advent of unleaded fuels in the mid-1970s, however, motor octane measurements have frequently been found to limit actual engine performance. As a result a new measurement, road octane number, which is a simple average of the research and motor values, is most frequently used to define fuel quality. Automotive gasolines generally range from research octane number 87 to 100, while gasoline for piston-engine aircraft ranges from research octane number 115 to 130.

Each naphtha component that is blended into gasoline is tested separately for its octane rating. Reformate, alkylate, polymer, and cracked naphtha, as well as butane, all rank high (90 or higher) on this scale, while straight-run naphtha may rank at 70 or less. In the 1920s it was discovered that the addition of tetraethyl lead would substantially enhance the octane rating of various naphthas. Each naphtha component was found to have a unique response to lead additives, some combinations being found to be synergistic and others antagonistic. This gave rise to very sophisticated techniques for designing the optimal blends of available components into desired grades of gasoline.

The advent of leaded, or ethyl, gasoline led to the manufacture of high-octane fuels and became universally employed throughout the world after World War II. Lead is still an essential component of high-octane aviation gasoline, but, beginning in 1975, environmental legislation in the United States restricted the use of lead additives in automotive gasoline. Similar restrictions have since been adopted in most developed countries. The required use of lead-free gasoline has placed a premium on the construction of new catalytic reformers and alkylation units for increasing yields of high-octane gasoline ingredients and on the exclusion of low-octane naphthas from the gasoline blend.

High-volatile and low-volatile components. The second major criterion for gasoline—that the fuel be sufficiently volatile to enable the car engine to start quickly in cold weather—is accomplished by the addition of butane, a very low-boiling paraffin, to the gasoline blend. Fortunately, butane is also a high-octane component with little alternate economic use, so its application has historically been maximized in gasoline. Another requirement, that a quality gasoline have a high energy content, has traditionally been satisfied by including higher-boiling components in the blend. However, both of these practices are now called into question on environmental grounds. The same high volatility that provides good starting characteristics in cold weather can lead to high evaporative losses of gasoline during refueling operations, and the inclusion of high-boiling components to increase the energy content of the gasoline can also increase the emission of unburned hydrocarbons from engines on start-up. As a result, since 1990 gasoline consumed in the United States has been reformulated to meet stringent new environmental standards. Among these changes are the inclusion of some oxygenated compounds in order to reduce the emission of carbon monoxide and nitrogen oxides.

Text 6